Post by djh on Nov 21, 2023 11:23:16 GMT -5
I can programme the SC1 with an NCE Powercab and activate signals.
However, if I power the SC1 from my Ecos 52000 I cannot read any CVs in Program mode, as I get an error message, the SC1 will not accept any addresses using the same inputs as the NCE. The signals which are programmed and working with the NCE do not respond.
Any guidance/solutions gratefully received
David
However, if I power the SC1 from my Ecos 52000 I cannot read any CVs in Program mode, as I get an error message, the SC1 will not accept any addresses using the same inputs as the NCE. The signals which are programmed and working with the NCE do not respond.
Any guidance/solutions gratefully received
David