|
Post by speedstor49 on Sept 17, 2013 9:27:07 GMT -5
Table 1 on Page 21 of the SC1 Manual mentions firmware versions under "Setting the signal type". How can I find out which firmware version I have on my two SC1 controllers?
|
|
|
Post by crsignals on Sept 23, 2013 14:54:54 GMT -5
Hi, Sorry for the delay in replying. Your boards have firmware version 0.23 loaded. I think this can be found under CV7 but looking at one of mine CV7 is showing a value of 9. Rest assured the firmware on these controllers is at the latest version. Regards, Paul
|
|
|
Post by speedstor49 on Sept 24, 2013 1:50:43 GMT -5
Thanks for your response. That has set my mind at rest. Sorry for my mistake. I should have said Table 1 on page 21 not page 11. I have now corrected my original post.
You certainly have an excellent product. I am looking forward to building the Dapol Semaphore signals interface and getting my new signals working.
|
|
|
Post by crsignals on Sept 24, 2013 5:28:43 GMT -5
I guessed it was page 21 that you were referring to. Many thanks for your comments regarding the product, always appreciated. Regards, Paul
|
|
|
Post by Paul Harman on Sept 24, 2013 21:12:55 GMT -5
Congratulations on being the first poster.
The minor firmware revision is two hex digits in CV 113. Version 0.23 for example will be 35 (2 x 16 + 3).
|
|
|
Post by speedstor49 on Dec 4, 2013 7:25:07 GMT -5
Thanks Paul. I haven't had to use hex since I did the CCNA course so it is good to stretch the old memory again.
|
|